Attaching A Ledger To Vinyl Siding

This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole.

Attaching a ledger to vinyl siding.

The ledger board is a horizontal framing member usually two by 10 or two by 12 lumber that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding. In order to install the ledger board you usually need to remove the house s siding. There are at least three alternative ways to do it. Make sure to install flashing under the siding extending over the ledger the flashing prevents the build up of moisture which causes rotting.

If you have beveled horizontal siding then use an inverted piece of siding as shown in the illustration here to create a plumb flat surface for attaching the ledger. Attach your ledger board to your vinyl siding properly to have a sturdy moisture proof deck support by following these steps. Attaching a deck ledger board to a vinyl sided house requires a few extra trim pieces to keep water from leaking behind the siding. Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.

Here are the steps to take when installing a ledger on a home with siding. By the diy experts of the family handyman magazine. Never install a ledger board over the top of siding no matter what you hear this can weaken the connection. Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.

Instead cut off a section of siding so ledger can be in complete contact with house. Relatively flat siding can remain intact but clapboard beveled wood metal or vinyl siding should always be cut away. If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. Use an inverted piece of cedar siding to create a.